Note:
(1) When no symbol applies or no appended symbol is needed, the symbol and the hyphen (-) before it are omitted.
(2) The model designations shown here are for the purpose of illustrating the symbols, and in some cases may denote models that do not actually exist.

Note:
The minimum product height needed for removing the belt.

Note:
(1) "(1)" indicates speed symbol 18. "(2)" shown for the constant-speed, IV variable speed and U variable speed types indicates a speed symbol range of 25 to 180.
DC variable speed types indicates a speed symbol range of 25,36.
(2) Each dimension shown is the maximum value among the motors available.(A:Sumitomo,O:Oriental,M:Panasonic)

Note:
(1) 40 W models are all timing belt types.
(2) Actual speeds may vary by up to 10% less than the values shown, depending on the motor characteristics and payload.
(3) Speeds of DC motor variable speed models may vary by up to 0.6% more or less than the values shown, depending on the motor characteristics and payload.
(4) DC motor variable-speed models are only available with motor symbol O (Oriental).
(5) Variable-speed models should only be used within the specified speed range since low-speed operation may cause motor

Note:
(1) Shaded drive values are for timing belt drive. Other values are for chain drive.
(2) Actual speeds may vary by up to 10% less than the values shown, depending on the motor characteristics and payload.
(3) Speeds of DC motor variable speed models may vary by up to 0.6% more or less than the values shown, depending on the motor characteristics and payload.
(4) DC motor variable-speed models are only available with motor symbol O (Oriental).
(5) Variable-speed models should only be used within the specified speed range since low-speed operation may cause motor burnout.

Various motive types(Specifications without description are the same as standard products.)

A conveyor with a short product length that uses a hollow shaft motor.
There is no motor symbol as this is a customized motor.

Dimensions

Specifications

Power supplies and speeds

Note:
(1) Actual speeds may vary by up to 10% less than the values shown, depending on the motor characteristics and payload.
(2) Variable-speed models should only be used within the specified speed range since low-speed operation may cause motor burnout.
(3) There is no motor symbol as this is a customized motor.

Options(Guide)

Option(Leg)